Fibre broadband downstream has switched to interleave.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Broadband
- :
- Fibre broadband downstream has switched to interle...
Fibre broadband downstream has switched to interleave.
01-12-2022 1:53 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Been with plusnet for years and my line has always been fast up and down. Noticed everything had gone a bit chuggish in the household and checked the router. Line stats below. Is there anyway to get this reset so that Im back on fastpath or am I stuck waiting for the BT algorithm. I did upgrade my Vigor 130's firmware recently, perhaps thats caused the issue. Pings are substantially worse.
Any help would be appreciated. Even knowing the cause would be a help.
Regards
Roger
---------------------- ATU-R Info (hw: annex A, f/w: annex A/B/C) -----------
Running Mode : 17A State : SHOWTIME
DS Actual Rate : 63307000 bps US Actual Rate : 20000000 bps
DS Attainable Rate : 73000504 bps US Attainable Rate : 20517320 bps
DS Path Mode : Interleave US Path Mode : Fast
DS Interleave Depth : 922 US Interleave Depth : 1
NE Current Attenuation : 15 dB Cur SNR Margin : 3 dB
DS actual PSD : 6. 5 dB US actual PSD : 6. 7 dB
NE CRC Count : 0 FE CRC Count : 2238
NE ES Count : 0 FE ES Count : 2001
Xdsl Reset Times : 0 Xdsl Link Times : 3
ITU Version[0] : fe004452 ITU Version[1] : 41590000
VDSL Firmware Version : 05-07-09-0F-01-07 [with Vectoring support]
Power Management Mode : DSL_G997_PMS_L0
Test Mode : DISABLE
-------------------------------- ATU-C Info ---------------------------------
Far Current Attenuation : 15 dB Far SNR Margin : 6 dB
CO ITU Version[0] : b5004946 CO ITU Version[1] : 544eb206
DSLAM Chipset Vendor: IFTN
Re: Fibre broadband downstream has switched to interleave.
06-12-2022 1:47 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Just seems strange that a few days before those stats, my line reported with a DS Interleave depth of 1 and Path Mode as Fast. Also connection speed was higher.
Re: Fibre broadband downstream has switched to interleave.
06-12-2022 3:01 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: Fibre broadband downstream has switched to interleave.
14-12-2022 7:42 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Same as always. Line had reset 3 times since the router had been reflashed.
I had flashed the router with a newer firmware, but I reflashed back after these issues occured. The stats below are how it is operating back on the original firmware.
---------------------- ATU-R Info (hw: annex A, f/w: annex A/B/C) -----------
Running Mode : 17A State : SHOWTIME
DS Actual Rate : 62755000 bps US Actual Rate : 20000000 bps
DS Attainable Rate : 72238312 bps US Attainable Rate : 20661528 bps
DS Path Mode : Interleave US Path Mode : Fast
DS Interleave Depth : 914 US Interleave Depth : 1
NE Current Attenuation : 15 dB Cur SNR Margin : 3 dB
DS actual PSD : 6. 5 dB US actual PSD : 6. 7 dB
NE CRC Count : 3 FE CRC Count : 3348
NE ES Count : 3 FE ES Count : 2997
Xdsl Reset Times : 0 Xdsl Link Times : 1
ITU Version[0] : fe004452 ITU Version[1] : 41590000
VDSL Firmware Version : 05-07-06-0D-01-07 [with Vectoring support]
Power Management Mode : DSL_G997_PMS_L0
Test Mode : DISABLE
-------------------------------- ATU-C Info ---------------------------------
Far Current Attenuation : 15 dB Far SNR Margin : 6 dB
CO ITU Version[0] : b5004946 CO ITU Version[1] : 544eb206
DSLAM CHIPSET VENDOR : < IFTN >
Re: Fibre broadband downstream has switched to interleave.
15-12-2022 9:03 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Thanks for responding @graham00
Normally we're not able to reset lines to remove interleaving but there's something we can try that might have the desired effect
It should kick in from tomorrow all being well
Re: Fibre broadband downstream has switched to interleave.
15-12-2022 3:34 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Thanks Ill check tomorrow.
Again thanks for all the help.
Re: Fibre broadband downstream has switched to interleave.
17-12-2022 3:31 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
I don't know if you tried the change, router stats are identical to what they were before.
Running Mode : 17A State : SHOWTIME
DS Actual Rate : 62755000 bps US Actual Rate : 20000000 bps
DS Attainable Rate : 72891688 bps US Attainable Rate : 20869782 bps
DS Path Mode : Interleave US Path Mode : Fast
DS Interleave Depth : 914 US Interleave Depth : 1
NE Current Attenuation : 15 dB Cur SNR Margin : 3 dB
DS actual PSD : 6. 5 dB US actual PSD : 6. 7 dB
NE CRC Count : 7 FE CRC Count : 3610
NE ES Count : 5 FE ES Count : 3222
Xdsl Reset Times : 0 Xdsl Link Times : 1
ITU Version[0] : fe004452 ITU Version[1] : 41590000
VDSL Firmware Version : 05-07-06-0D-01-07 [with Vectoring support]
Power Management Mode : DSL_G997_PMS_L0
Test Mode : DISABLE
-------------------------------- ATU-C Info ---------------------------------
Far Current Attenuation : 15 dB Far SNR Margin : 6 dB
CO ITU Version[0] : b5004946 CO ITU Version[1] : 544eb206
DSLAM CHIPSET VENDOR : < IFTN >
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Broadband
- :
- Fibre broadband downstream has switched to interle...