cancel
Showing results for 
Search instead for 
Did you mean: 

FTTP Instalation

Batfrog
Aspiring Pro
Posts: 121
Thanks: 61
Registered: ‎13-06-2023

FTTP Instalation

I’ve got Openreach coming in a couple of weeks to install an ONT which is not really a problem as such.

The ONT can go in one or two places but my preferred option means the inside fibre passing along the inside of a hollow wall (plasterboard and batons) for about 2 metres for which a ‘fish’ wire is already in place.

This wouldn’t be a problem for say a DSL or network cable etc which would pass easily but I’m wondering if OR would pass a fibre cable through such a route even though there are no sharp curves.

I’m wondering mainly if both ends of the inside fibre are terminated on site or ready-made which, would probably scupper my plan ?

Anybody have any experience of this ?

Tags (2)
5 REPLIES 5
2u2me
Pro
Posts: 355
Thanks: 96
Fixes: 3
Registered: ‎27-09-2013

Re: FTTP Instalation

The cable that connects to the ONT has a manufactured green plug already installed on it, the coil is run to the outside CSP and then spliced to it, (coil is about 10mtrs long) so you will be OK.

Batfrog
Aspiring Pro
Posts: 121
Thanks: 61
Registered: ‎13-06-2023

Re: FTTP Instalation

Great thanks.

I wondered why they drill a 12mm hole for a 3mm cable but I guess it may be a 'sleeved' hole ?

MisterW
Superuser
Superuser
Posts: 16,202
Thanks: 6,182
Fixes: 447
Registered: ‎30-07-2007

Re: FTTP Instalation

There,is a plastic sleeve insertedc into the hole. It has,a cover over the internal hole to control the bend of the fibre and to retain it to allow a small loop to. connect to the ONT

Superusers are not staff, but they do have a direct line of communication into the business in order to raise issues, concerns and feedback from the community.

Batfrog
Aspiring Pro
Posts: 121
Thanks: 61
Registered: ‎13-06-2023

Re: FTTP Instalation

Great thanks. It should be an interesting experience.

Batfrog
Aspiring Pro
Posts: 121
Thanks: 61
Registered: ‎13-06-2023

Re: FTTP Instalation

Well it all went well, Openreach (MJ Quinn actually) came at the appointed time, installed the new fibre line, removed the old copper and installed the new line exactly where I wanted. It was my second choice but my first choice would have meant he would have had to splice the cable up a ladder – just not practical !! All done very neatly, connected up, and running within 90 minutes which apparently is the allotted time for the job.

Curiously (to me anyway) I was using my FTTC when he arrived and chopped the old copper off at the pole and when the fibre was connected it registered almost immediately and I was back on line at the full 75Mbs. None of this wait for 24 hours etc, etc.

He was still in his van in the street when I applied to my VOIP supplier (Virtual Landline) to port my old number to them. They replied within the hour saying they had applied to the LCP (Loosing Communication Provider) to transfer my old number and this morning (18 hours later) they sent me an email to say the losing provider – Plusnet had agreed and given a date 12 days from now at 11:00am ? So far so good but after some of the horror stories of lost numbers I’ll be keeping my fingers crossed until it’s done !

I was a little surprised that the OR man was alone considering he had to climb the nearby pole in the frosty sub-zero temperatures – health and safety being what it is nowadays !

My new deal with Plusnet involved a gift voucher which they sent the application email for the day before the installation date ? so that’s now applied for as well.

The point of this ramble is to show that sometimes, probably most of the time (for the silent majority) things do go to plan and the technology works as it should.