smart hub 2

[#1]

Hi all does anyone know if the smart hub 2 will work on PlusNet FTTP i know its works on vdsl mode also i know plusnet uses the same model but different colour i just want to save on p&p if i can. Thanks

[#2]

@mike360 It does - you just have to change the username/password. Details pinned to the top of the 'My Router' board. Unless you are using it already on a PN service, in which case, no change is required.

[#3]

thank you so much

[#4]

No problem.

[#5]

It will *if* it's either an FTTP model, or on a fairly recent firmware (where there is a toggle in the firmware to switch it between FTTC/P modes).

Originally it came in two flavours, one with all four ports designated as LAN ports and another with the fourth LAN port converted to a WAN port (same as the Plusnet Hub Two).

I think there may be some knocking about that are FTTC configured and still on an older firmware that doesn't have the toggle. If so, that could cause you problems. 

[#6]

Thanks, @bobpullen  - wasn't aware of that. Will bear it in mind.

[#7]

ive got the one with wan port is that going be a problem iv already order fttp without a router iv only just seen the messages 

[#8]

@mike360 you should be OK - but I'll let @bobpullen confirm.

[#9]

---

@mike360 wrote:

ive got the one with wan port is that going be a problem iv already order fttp without a router iv only just seen the messages 

---

Should be fine then 👍

[#10]

Moderators Note

This topic has been moved from Full Fibre to My Router