Plusnet FFTP setup for TPlink Vr2800

[#1]

Getting FFTP full fibre installed tomorrow and not 100% of the configuration needed in the VR2800 for it to work?

Anyone got experience of the configuration setup? 

I understand a cat 6 between BT Terminal and WAN port on router. not sure internet connection type or VLAN Id number?

[#2]

Internet connection PPPoE, vlan ID disabled

[#3]

touch wood get mine turned (FTTC) on tomorrow as well... as far as I know you only need:

username@plusdsl.net

PPPoE

will let you know if anything different, as I to am using a Tp-link AC2800 (Archer VR2800)...

[#4]

@infinite  for FTTC you will also need vlan ID set to  101

[#5]

I have a TPLink Archer VR2800. I have upgraded to full fibre today and am trying to get my router to work with full fibre rather than using the one supplied by Plusnet. I have done the following things and I'm facing no internet connectivity; 

Set the operation mode from DSL modem router mode to Wireless Router Mode (I did this because it was expecting me to connect to a phone line which I no longer have)

Connection type:  PPPoE

Username and password same as works on the new plusnet router.

Vlan ID to 101

However, it will not connect. Any ideas?

[#6]

@midnite VLAN ID is 'none' - it is not used with a Full Fibre connection.

[#7]

@midnite 

From a google search.. " Does  The Archer VR2800 work with fibre broadband".

The Archer VR2800 has one DSL port and 4 ethernet ports, but no fibre port, to make it work, you need buy a fibre modem, so that we can connect it to the fibre cable provided by ISP and connect the modem to VR2800 and get internet.

[#8]

Thanks @shutter . Although, AFAIK, the ONT is a 'modem'.

[#9]

I'm happy to get a new router etc. What do I need to look for in terms of it supporting full fibre.

Would something like this https://www.amazon.co.uk/dp/B08C3VRM6M work? It has the lan2/p6 port on there which I believe is necessary.

Thanks in advance

[#10]

@midnite I would wait for @MisterW or one of the other Community members who understand FF to respond before you take any action.

[#11]

and here he is!

@midnite The vr2800 should work fine in wireless router mode. Connect the ONT to lan port 4 (wan port ) configure pppoe and as@jab1  says , disable vlan id

If it doesn't work then try a factory reset and start by setting wireless router mode first.

[#12]

For clarification what is ONT?

[#13]

The white box BT will have installed in place of your master socket.

[#14]

Optical Network Termination

[#15]

Thanks everyone for your help. Managed to get it all set up.