TP-Link TL-WPA4220 - Causes Plusnet Modem to reset

[#1]

I have just purchased a  TL-WPA4220 powerline extender and every so often (I cannot see a pattern) it causes my Plusnet router to reset itself, causing all devices on the network to lose connectivity, There are a number of mentions of this problem on the Internet but cannot find a solution. I have a few days before I return the kit to the shop but before I do, is there anyone here who has experienced the problem and solved it?

[#2]

@Nickellis Would your router be a Hub one by any chance ?

if so does the event log contain any messages like 'watchdog reset' ?

[#3]

Thank you for a prompt reply

Looked at the log and cannot find this message. I did not take a note of the time of the errors, but will do in the future. I have attached the log, since the device was first used to this reply. The MAC address of the TP Link is:  1c:61:b4:4a:83:f6

[#4]

Oddly the router went down as I was sending the above message; 

I attach the log for that period

[#5]

I cant see any router reset in there. There is a DSL drop at 14:10:08. I suspect the TP link MAY be causing electrical noise which is affecting the phone line and causing the DSL drop

[#6]

Thanks again for the reply, I will continue to monitor the situation, to see if there is a pattern to this.

[#7]

Could this issue be something to do with Ipv6? It's just that the logs show no reference to this unless the TP Link is plugged in? 

[#8]

I doubt it but you could always disable ipv6 on the Hub to eliminate it.